How a roller stamp works

Five steps to a clean band

1. Step 1

   Insert the marker

   Slide the matched ink marker into the LogoRolly handle.

2. Step 2

   Check contact

   Make sure the marker tip sits flush against the engraved roll.

3. Step 3

   Place it down

   Set the roller flat on your surface where the band should start.

4. Step 4

   Roll smoothly

   Roll in one steady motion, the imprint repeats as you go.

5. Step 5

   Don't press hard

   Let the ink do the work; light, even pressure gives the cleanest band.

Which ink for which surface?

Match the ink to your material. Acrylic is the safe, ships-anywhere default; solvent inks suit specific surfaces but can have shipping limits.

Artwork tips

• •Use mostly uppercase letters, they transfer most cleanly.
• •Avoid lines thinner than ~1mm and very fine detail.Avoid lines thinner than ~0.04" and very fine detail.
• •Skip ultra-thin, script or heavily decorative fonts.
• •Keep horizontal gaps small for a continuous-looking band.
• •Send logos as vector (.svg, .eps, .ai, .pdf) for the sharpest engraving.